adaptech Posted December 25, 2016 Share Posted December 25, 2016 Hello all, I am considering replacing my old and problematic Millplus controller to a new one, Delta Tau seems to offer everything which is necessary. The machine is a DMU 60 P from 1999 with Simodrive 611 drives et 1FT6 motors plus Heidenhain rules. These are operating well and I would like to keep them, in this case which hardware should I chose from Delta Tau to replace the millplus? Cordially Francois Link to comment Share on other sites More sharing options...
Gregs Posted December 29, 2016 Share Posted December 29, 2016 Hello Francois, The main thing is that I am not sure about the interface for those drives, but one of our CNC guys will be able to look into this next week. I suggest sending an email to Support@DeltaTau.com with any extra information you can provide, such as including I/O requirements. There will be questions regarding getting integrator assistance, and how much, based on your Delta Tau experience and on how much you want to learn or get training. Link to comment Share on other sites More sharing options...
Recommended Posts