Jump to content
OMRON Forums

Starting with Turbo Pmac


Mathew

Recommended Posts

Hello everyone , I sort of have a long story but our company bought a CNC design from a smaller company which uses turbo PMAC and long term were supposed to be tech support for this new control . As of now I know nothing of the PMAC systems , does anyone have any advice on how to start learning Turbo Pmac ,

 

Has anyone taken the training from Delta Tau's facility in California and it is friendly to completely new users ?

 

I know servo PID concept and general programming knowledge so hopefully its not too much over my head.

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

If you know PID and programming, you will likely do very well in the training.

 

You can download the whole slides from FileDepot and read through them in advance. If you have some of your own hardware, you can probably do all the exercises. Just email support to ask for a virtual motor file if you do not have real motors or do not want to move the ones you have.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...