RomanSolonto Posted October 25, 2016 Share Posted October 25, 2016 Good day. I'd download new firmware (2.1.1.3) on PowerClipper. IDE version is 2.2.0.39. When I start IDE I receive error Sys.NoClocks and Sys.ServoCount is 0. Before updating Sys.ServoCount was updating. Link to comment Share on other sites More sharing options...
steve.milici Posted October 25, 2016 Share Posted October 25, 2016 What was the previous firmware? What is the bar code serial number of this card? Verify the updated firmware was correctly installed with the "vers" command. Capture the "boot response" on the serial port and email this to support@deltatau.com. Link to comment Share on other sites More sharing options...
RomanSolonto Posted October 26, 2016 Author Share Posted October 26, 2016 Previous firmware version was 1.6.0.119. S/n DEUP-08GI21C1T ASSY 604050-100 Vers 2.1.1.3 Power clipper. "2.1.1.3 powerpmac465.zip " was used. In Errors monitor I have: Sys.Gate1AddrErrDetect = 0x5554 Sys.NoClocks = 1 How can I capture "boot response"? Can it be captured only from serial port? Thank you. Link to comment Share on other sites More sharing options...
steve.milici Posted October 26, 2016 Share Posted October 26, 2016 Yes - only through the serial port. I suspect you have one of the original Power Clippers. I would like to have the barcode serial number to verify. This is now a technical support issue. Contact me at support@deltatau.com. I will provide you with a procedure to restore the clocking system of the card. Link to comment Share on other sites More sharing options...
Recommended Posts