Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACC11C OPT1 M Variable
#1
HI,

Im using a power pmac cpci format.
I would like to declare M variables that point to my IOs of the ACC11C opt1.
unfortunately the IDE didn't detect the option on this card.

hereafter an example:

M1098->Acc11C[_ACC11C_INDEX_].CtrlReg; configured to 15 (32 IN 16 OUT)

M1000->ACC11C[_ACC11C_INDEX_].DataReg[0].0.1; ACC11C In1(u.io:$A00000.8.1 )


now the only method that i found to point to the first input of the option card
is
M1033->u.io:$A00000.16.1 ;

question: is there a trick to declare M1033 as I did for M1000 ?
Reply
#2
This card should be auto detected.

What is your PMAC firmware and IDE version?

What is the response for the following:
Gateio[i].PartNum
Gateio[i].PartOpt
Gateio[i].PartRev
Gateio[i].PartType

I will check with our Production Test group for verification of the programming.
Reply
#3
Also please provide the barcode s/n of the card.
Reply
#4
HI,
herafter the response to your queries:
IDE 2.2.0.39
Base card S/N:C000EBHH
mezzanine card S/N: C000CQ5W
terminal command responses:
vers
2.0.2.14
Gateio[0].PartNum
Gateio[0].PartOpt
Gateio[0].PartRev
Gateio[0].PartType
GateIo[0].PartNum=603603
GateIo[0].PartOpt=$1ff
GateIo[0].PartRev=6
GateIo[0].PartType=8
Reply
#5
At this time the firmware does not recognize the option setting. The I/O access is by direct memory reference only.

The firmware engineers are looking into this for a future release.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)