09-29-2016, 02:32 PM
I assumed that I could copy the .cfg file from my 4-axis pmac to my 8 axis one and my channels 1-4 would work the same. This post suggests it should:
http://forums.deltatau.com/showthread.ph...645#pid645
Unfortunately it doesn't. As I move the motors by hand I see a correct change in position but when using the jog ribbon I can just feel an occasional small pulse, esp when I hit the Kill All button. Programs don't run at all.
What parameters do you think need changing?
http://forums.deltatau.com/showthread.ph...645#pid645
Unfortunately it doesn't. As I move the motors by hand I see a correct change in position but when using the jog ribbon I can just feel an occasional small pulse, esp when I hit the Kill All button. Programs don't run at all.
What parameters do you think need changing?