killerisation Posted September 29, 2016 Share Posted September 29, 2016 I assumed that I could copy the .cfg file from my 4-axis pmac to my 8 axis one and my channels 1-4 would work the same. This post suggests it should: http://forums.deltatau.com/showthread.php?tid=261&pid=645#pid645 Unfortunately it doesn't. As I move the motors by hand I see a correct change in position but when using the jog ribbon I can just feel an occasional small pulse, esp when I hit the Kill All button. Programs don't run at all. What parameters do you think need changing? Link to comment Share on other sites More sharing options...
steve.milici Posted September 30, 2016 Share Posted September 30, 2016 Please contact our Technical support group and send your configuration file to: support@deltatau.com Link to comment Share on other sites More sharing options...
Recommended Posts