andreychip Posted September 9, 2016 Share Posted September 9, 2016 Hello. We have a PowerClipper firmware version 2.0.2.14. Working with PoverIDE version 2.0.3.40 4/21/2015, no problem, attached screenshots . When you install the new PowerClipper version 2.2.0.39 7/16/2016 we had a problem with the configuration EtherChat: 9/9/2016 :9:46 AM - 192.168.10.200, Module - Setup Motor : Error - EtherCAT setup requires a Firmware upgrade to version 2.0.2.210 or newer. Attached screenshots below. best regards. Link to comment Share on other sites More sharing options...
steve.milici Posted September 9, 2016 Share Posted September 9, 2016 What is the response to the "vers" command? Link to comment Share on other sites More sharing options...
andreychip Posted September 9, 2016 Author Share Posted September 9, 2016 What is the response to the "vers" command? a task manager screenshot Link to comment Share on other sites More sharing options...
andreychip Posted September 9, 2016 Author Share Posted September 9, 2016 You can get new firmware on the PowerPmac Clipper controller and the instructions how to sew. Link to comment Share on other sites More sharing options...
steve.milici Posted September 9, 2016 Share Posted September 9, 2016 The message you received was: 9/9/2016 :9:46 AM - 192.168.10.200, Module - Setup Motor : Error - EtherCAT setup requires a Firmware upgrade to version 2.0.2.210 or newer. Your firmware version is only 2.0.2.14. You must upgrade your firmware to version 2.1.0.39 or higher. Link to comment Share on other sites More sharing options...
steve.milici Posted September 9, 2016 Share Posted September 9, 2016 You can download the firmware from the FileDepot at: "http://forums.deltatau.com/filedepot/download.php?f=Power PMAC/Firmware/Release/2.1.0.39/2.1.0.39-465.zip" Use the IDE's firmware download under "Delta Tau" menu, "Configure" then "Download Firmware". Link to comment Share on other sites More sharing options...
andreychip Posted September 9, 2016 Author Share Posted September 9, 2016 thank you very much Link to comment Share on other sites More sharing options...
andreychip Posted September 9, 2016 Author Share Posted September 9, 2016 What to do with the files in the firmware and ppmac.zip sourcediff.zip ? Link to comment Share on other sites More sharing options...
steve.milici Posted September 9, 2016 Share Posted September 9, 2016 You only need the ".deb" file. Link to comment Share on other sites More sharing options...
andreychip Posted September 9, 2016 Author Share Posted September 9, 2016 thank you very much Link to comment Share on other sites More sharing options...
Recommended Posts