Jump to content
OMRON Forums

Ix26


posalux

Recommended Posts

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Check for "in position" status and perhaps check that following error is minimal before issuing HMZ.

 

I believe it is Ix10 that should be 0 to disable absolute position sensor setup. Note that Ix95 in Non-Turbo is different than Ixx95 in Turbo.

Link to comment
Share on other sites

Yes, it is -8388608 to 8388608 just like the manual says. Do you have a copy of the Turbo SRM manual?

 

Sorry ,yes it is in the manual .

And I will start the program with a jogging to the end of the table and do a HOMEZ.

Thanks for the quickly respons !

Link to comment
Share on other sites

Check for "in position" status and perhaps check that following error is minimal before issuing HMZ.

 

I believe it is Ix10 that should be 0 to disable absolute position sensor setup. Note that Ix95 in Non-Turbo is different than Ixx95 in Turbo.

 

I use the table for woodworking and as long the starting point is +/- 1mm it is OK.

Thanks for the respons.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...