Jump to content
OMRON Forums

C axis mode slow


dzrong

Recommended Posts

Hello EveryOne,

 

Why my C axis run so slow,only 20 block per second,

The unit of C is degree.

Coord[1].AltFeedRate=1000000

Motor[3].MaxSpeed=1000

Coord[1].PosRollover[2]=-360

 

 

Here is the program:

 

&1#1->1000000X-30000000

&1#2->1000000Z-30000000

&1#3->C

//

 

open prog 4

// --------------------User Code Goes Here------------------------

linear

abs

ta 1

ts 0

tm 1

 

C 0.01

C 0.02

C 0.03

C 0.04

C 0.05

C 0.06

C 0.07

C 0.08

C 0.09

C 0.1

C 0.11

C 0.12

C 0.13

C 0.14

C 0.15

C 0.16

C 0.17

C 0.18

C 0.19

C 0.2

C 0.21

C 0.22

C 0.23

C 0.24

C 0.25

C 0.26

C 0.27

C 0.28

C 0.29

C 0.3

C 0.31

C 0.32

C 0.33

C 0.34

C 0.35

C 0.36

C 0.37

C 0.38

C 0.39

C 0.4

C 0.41

C 0.42

C 0.43

C 0.44

C 0.45

C 0.46

C 0.47

C 0.48

C 0.49

C 0.5

C 0.51

C 0.52

C 0.53

C 0.54

C 0.55

C 0.56

C 0.57

C 0.58

C 0.59

C 0.6

C 0.61

C 0.62

C 0.63

C 0.64

C 0.65

C 0.66

C 0.67

C 0.68

C 0.69

C 0.7

C 0.71

C 0.72

C 0.73

C 0.74

C 0.75

C 0.76

C 0.77

C 0.78

C 0.79

C 0.8

C 0.81

C 0.82

C 0.83

C 0.84

C 0.85

C 0.86

C 0.87

C 0.88

C 0.89

C 0.9

C 0.91

C 0.92

C 0.93

C 0.94

C 0.95

C 0.96

C 0.97

C 0.98

C 0.99

C 1

 

close

Link to comment
Share on other sites

  • Replies 6
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...