Jump to content
OMRON Forums

GateIO address detection


DT-Europe

Recommended Posts

The IO Gate addresses detected don't reflect the dip switch setting done on the different IO boards, but the memory map to access th IO is correct. e.g. setting of our dip switches ACC66E first | $B00000 | Gate IO 4 | ACC66E second | $B08000 | Gate IO 5 | The 1st ACC66E is responding on $B00000 but is detected in the sys.CardIOAutoDetect in a wrong bit and the intellisense GateIO[1] instead of GateIO[4].
Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

[quote=DT-Europe] The IO Gate addresses detected don't reflect the dip switch setting done on the different IO boards, but the memory map to access th IO is correct. e.g. setting of our dip switches ACC66E first | $B00000 | Gate IO 4 | ACC66E second | $B08000 | Gate IO 5 | The 1st ACC66E is responding on $B00000 but is detected in the sys.CardIOAutoDetect in a wrong bit and the intellisense GateIO[1] instead of GateIO[4]. [/quote] The attached document contains the proper indexes.
Link to comment
Share on other sites

  • 8 months later...
Guest
This topic is now closed to further replies.

×
×
  • Create New...