Jump to content
OMRON Forums

How to get the abs position from an Endat2.2 with incremental encoder?


dzrong

Recommended Posts

Hello Everyone,

 

I'm using ACC84E with PPmac,and want to get the abs position from an Endat2.2 with incremental encoder,The type of Linear grating is LIP211,0.03125nm per count(LSB).A 36($24)-bit encoder from HEIDENHAIN.

 

Now the position can be read correctly throw Acc84E[1].Chan[0].SerialEncDataA and Acc84E[1].Chan[0].SerialEncDataB after some setting like:

Acc84E[1].SerialEncCtrl=$002003;

Acc84E[1].Chan[0].SerialEncCmd =$071424;

 

But I can't get a valid data of the RM_bit ,it's always zero even I move the motor go throw the whole trip by hand. Of course proper command codes had been send before,like:

Acc84E[1].Chan[0].SerialEncCmd = $381424

Acc84E[1].Chan[0].SerialEncCmd = $421424

 

Because RM_bit is one bit of Acc84E[1].Chan[0].SerialEncDataC.SerialEncDataC is always zero,so RM_bit should be zero.

 

And the ACC84E very new,should be the latest firmware to support the function.

 

Does Anyone had using the Encoder like me? Can you give some suggestion?

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...