03-09-2016, 10:12 AM
Is there any thing in the NC pro2 software that sets or changes the encoder
conversion table entry's past entry 8?
conversion table entry's past entry 8?
NC pro2 and the encoder conv table
|
03-09-2016, 10:12 AM
Is there any thing in the NC pro2 software that sets or changes the encoder
conversion table entry's past entry 8?
03-10-2016, 10:08 AM
The NC will only “modify” the triggered time-base entry for the spindle encoder during certain Lathe threading G-codes. For a four axis PMAC this is usually entry #5. For an eight axis PMAC this is usually entry #9.
03-10-2016, 03:28 PM
(03-10-2016, 10:08 AM)steve.milici Wrote: The NC will only “modify” the triggered time-base entry for the spindle encoder during certain Lathe threading G-codes. For a four axis PMAC this is usually entry #5. For an eight axis PMAC this is usually entry #9. Steve, Yea I found the setting in the OEM.h file setting up those table entries. Got it squared away. |
« Next Oldest | Next Newest »
|