Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NC pro2 and the encoder conv table
#1
Is there any thing in the NC pro2 software that sets or changes the encoder
conversion table entry's past entry 8?
Reply
#2
The NC will only “modify” the triggered time-base entry for the spindle encoder during certain Lathe threading G-codes. For a four axis PMAC this is usually entry #5. For an eight axis PMAC this is usually entry #9.
Reply
#3
(03-10-2016, 10:08 AM)steve.milici Wrote: The NC will only “modify” the triggered time-base entry for the spindle encoder during certain Lathe threading G-codes. For a four axis PMAC this is usually entry #5. For an eight axis PMAC this is usually entry #9.

Steve,
Yea I found the setting in the OEM.h file setting up those table entries.
Got it squared away.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)