11-16-2015, 06:17 AM
System was running fine.
Now whenever I switch into Auto mode or MDI mode I get this alarm
"Syntax Fatal: Can Not Close Rotary Buffer! File C:\Part Progams\......"
I noticed the rotary buffer display on the NC display "Buffer Closed" "0/0"
This alarm locks up the NC software!
Now whenever I switch into Auto mode or MDI mode I get this alarm
"Syntax Fatal: Can Not Close Rotary Buffer! File C:\Part Progams\......"
I noticed the rotary buffer display on the NC display "Buffer Closed" "0/0"
This alarm locks up the NC software!