Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
M code aliasing
#1
Has anyone used the M code aliasing feature? The manual says to edit the alias.ini file. This file doesn't exist. Even if I create it the aliasing doesn't work. The registry says the aliasing file name is NcMcodeAlias.dat. This file name doesn't work either. Any suggestions?
Reply
#2
(06-11-2010, 02:07 PM)progrind Wrote: Has anyone used the M code aliasing feature? The manual says to edit the alias.ini file. This file doesn't exist. Even if I create it the aliasing doesn't work. The registry says the aliasing file name is NcMcodeAlias.dat. This file name doesn't work either. Any suggestions?

This feature should be operational. Send an E-mail to "Steve Milici" <smilici@deltatau.com> describing the setup you did for this feature. I will take a look at it to see if I can determine what the problem is.
Reply
#3
The final word on this is that it doesn't work. The M code calls will not pass any variables or call a subprogram. The work around for passing variables is something like this.
G103P1 //look ahead off
G10.1 P1000 K#100 // Passes the value of #100 to P1000
M06 //P1000 is available for use in the M06 code
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)