aims Posted July 14, 2015 Share Posted July 14, 2015 I would like to i use JTHW port as general purpose I/O. May I make and break 24VDC circuit connection? or it only for 5 VDC? Could you please provide writing diagram for the I/O? Link to comment Share on other sites More sharing options...
chrisb Posted July 14, 2015 Share Posted July 14, 2015 I would like to i use JTHW port as general purpose I/O. May I make and break 24VDC circuit connection? or it only for 5 VDC? Could you please provide writing diagram for the I/O? The JTHW is TTL level only. You cannot drive or input 24VDC. You would need to use external Opto-isolators. Link to comment Share on other sites More sharing options...
steve.milici Posted July 14, 2015 Share Posted July 14, 2015 Also note that the schematic is in the Clipper manual. Link to comment Share on other sites More sharing options...
aims Posted July 15, 2015 Author Share Posted July 15, 2015 Alright, got it. Yup I found the wiring diagram it in the last page. My apologize. Thank you Link to comment Share on other sites More sharing options...
aims Posted July 15, 2015 Author Share Posted July 15, 2015 Do the AENA output is okay to make a 24VDC connection? Link to comment Share on other sites More sharing options...
steve.milici Posted July 15, 2015 Share Posted July 15, 2015 The AENA can sink a 24v drive enable input - just make sure the amplifier's 24v is ground referenced to the Clipper (usually GND of J3 to GND of amplifier). Link to comment Share on other sites More sharing options...
Recommended Posts