Delta Tau Forums › Delta Tau Data Systems › Power PMAC › Manuals and Documentation
Setup Variable

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Setup Variable
aims Offline
Junior Member
**
Posts: 42
Threads: 16
Joined: May 2010
#1
05-18-2015, 09:14 PM
Hi, I want to ask why there is nothing in my setup variable? As attachment. Because I found that there must be something on the setup variable as I read the training slides there. Am I less configure something?
Find
Reply
AAnikstein Offline
Delta Tau Insider
*******
Delta Tau Insider
Posts: 150
Threads: 4
Joined: Aug 2013
#2
05-19-2015, 01:58 PM
Please email us at Support at DeltaTau dot com. There is a known firmware issue that may be causing this, so I would like to confirm what version you have and help accordingly. That said, to set up a system, you shouldn't really need to go through the Setup Variables window, you should be able to do everything you need with the Terminal or the System Setup tool.
Find
Reply
aims Offline
Junior Member
**
Posts: 42
Threads: 16
Joined: May 2010
#3
05-20-2015, 09:03 PM
Hi, my system setup show 'In Development' for my power clipper. How to fix this problem? Is my software problem? My Power Pmac IDE is 2.0.0.25.
Find
Reply
*** Offline
Banned
Posts: 527
Threads: 22
Joined: Jun 2010
#4
05-21-2015, 10:53 AM
It says "In Development" because it's in development.

You should still be able to proceed and set up a motor, however. The screen to which you refer is just a status page.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)