Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Power Clipper with ACC-8ES & ACC8-AS
#1
I'm tryinng to install ACC-8ES on Power Clipper.

Please let me know setting parameter.
Reply
#2
Use the System Setup of the IDE. It will automatically set up these accessories.
Reply
#3
I am trying to set-up the 8ES accessory with the Power Clipper, but the IDE set-up does not work.
I upgraded the Power clipper with the latest firmware (in 2 steps) and the latest IDE.
For some reason the setup utility does not work, I get the following error messages.
Can you give me the settings for the DACstrobe and DACshift?


Outputs
system ethercat -m0 xml //11/17/2016 :12:53 PM - 192.168.0.200
system ethercat master // 11/17/2016 :12:53 PM - 192.168.0.200
Sys.MaxEcats = 1 // 11/17/2016 :12:53 PM - 192.168.0.200
Error messages
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : Global mask: 0xffffffff
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : CS mask: 0x201ffc
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : Motor mask: 0xc01ffd
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : Macro ring mask: 0x1e
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : Update period: 1.000000 Sec
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : Sys.Default=1 @ 17-11-2016 12:53:13
Debug messages
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor Container : There was some error while executing database query. Details : Database Error:Table 'ppmac192_168_0_200.hardware_tbl1' doesn't exist.
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor : There are no EtherCAT devices connect to Master[0].
11/17/2016 :12:53 PM - 192.168.0.200, Module - Setup Motor Container : There was some error while executing database query. Details : Database Error:Table 'ppmac192_168_0_200.hardware_tbl1' doesn't exist.
11/17/2016 :12:53 PM - 192.168.0.200, Module - Global Clock : Empty Servo hardware List
Reply
#4
Gate3[1].DacStrobe=$FFFFC000 or =$FFFFE000. Motor[x].DacShift=0. I will work on a configuration, but meanwhile, please email your configuration to Support@Deltatau.com.
Reply
#5
Dacstrobe =$7fffc000 works.

I already tried that value before, but it did not look correct since the command signal still changed after the out0 command, slowly climbing to 10V.
Looking a bit further I noticed this was cause by the fact the current loop enabled by default!

So the signal changed was probably caused by the offset on the analog input.
After setting motor[].pAdc =0 everything worked fine.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)