Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
analog and pulse setting
#1
Hi,

if connecting one axis for pulse and direction and other one axis is connect analog to driver.
How to do the setting on Power PMAC Clipper?
Reply
#2
Hi,

You can see the setup for analog starting on page 53 of the Power Clipper manual, and the PFM output setup starting on page 59. Just copy the settings for one mode for the motors you need, and the settings for the other mode for the other motors.

You can get that manual from the FileDepot, whose link is at the upper-right corner of this forum page.

If you have specific questions, email support at deltatau dot com.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)