Jump to content
OMRON Forums

Kinematic run without running a program


NigelInWindsor

Recommended Posts

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Depends where you want the result. If you send the &1p command then the reported data uses the forward kinematics so the routine that sends this command will receive the results. In the forward kinematics you could easily put these results into some global variables so they are then available to all routines in PPmac. You could also embed the forward kinematics in a cfromscript() which could just as well be called from any other script program.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...