Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How do configure an open loop for the picomotor piloted by puls/dir
Hi everyone,
Do you know how to configure a picomotor NewFocus 8301 in open loop ? This picomotor is piloted by puls/dir signal via the NewFocus Driver and use incremental encoder.

I haven't, but if you provide specifications about the motor, or even send us one, we can help you further.

We have done control of piezeoelectric motors, in general, and can provide you with control algorithm suggestions in that case if you desire.

Forum Jump:

Users browsing this thread: 1 Guest(s)