Jump to content
OMRON Forums

Power Brick Controller Manual


Omron Forums Support

Recommended Posts

  • 5 months later...
  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

  • 1 year later...
  • 1 year later...

"Do not mix topologies for outputs. They are all either sinking or sourcing per connector (X16 / X17)." p.103 should be X15/X16.

 

Please redraw diagram on p.104 to clarify input and output commons. Typical usage in my experience has been to implement a single topology (i.e. all PNP or all NPN, not split between PNP/NPN inputs and outputs). As it is, descriptions for pins 11/29 on X15/X16 are confusing (COM_EMT and COM_COL imply opposing terminals of a transistor yet both diagrams on p.104 show them connected to the same reference voltage).

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...