kebitmatf Posted January 8, 2015 Share Posted January 8, 2015 Dear Everyone, I'm using Model Clipper T1 to control a motor that is scan a sensor in a line. During the moving of the motor, the sensor is getting data at each interval distance (scanning resolution). To do this, 1 output pulse from the clipper will trigger the sensor to get 1 signal. I'm using the PCOMM32.DLL in Visual Basic 6.0. But, I don't know what is the command used to control the pulse output. Could someone help me to solve this problem? Link to comment Share on other sites More sharing options...
kebitmatf Posted January 8, 2015 Author Share Posted January 8, 2015 Dear Everyone, I'm using Model Clipper T1 to control a motor that is scan a sensor in a line. During the moving of the motor, the sensor is getting data at each interval distance (scanning resolution). To do this, 1 output pulse from the clipper will trigger the sensor to get 1 signal. I'm using the PCOMM32.DLL in Visual Basic 6.0. But, I don't know what is the command used to control the pulse output. Could someone help me to solve this problem? Link to comment Share on other sites More sharing options...
steve.milici Posted January 8, 2015 Share Posted January 8, 2015 What output pin are you using? Link to comment Share on other sites More sharing options...
steve.milici Posted January 8, 2015 Share Posted January 8, 2015 What output pin are you using? Link to comment Share on other sites More sharing options...
kebitmatf Posted January 8, 2015 Author Share Posted January 8, 2015 Actually, I don't know well which pin should I use. Please give me a suggestion! Link to comment Share on other sites More sharing options...
kebitmatf Posted January 8, 2015 Author Share Posted January 8, 2015 Actually, I don't know well which pin should I use. Please give me a suggestion! Link to comment Share on other sites More sharing options...
Recommended Posts