Jump to content
OMRON Forums

Comp Table Setup Issues


iclim

Recommended Posts

Hi we are having an issue with the Comp Table Setup tool and we wanted to know if this is common and if others are experiencing the same issue.

 

We have two specific issues with the Comp Table Setup:

1. The 'boundary mode' cannot be set to 0 or 1 but NOT 2. If this something that will be fixed in the next IDE release ??

 

2. When we attempt to upload compensation values it returns the following error

Bad data in line 256 with error: Index was outside the bounds of the array. Resetting data to 0.0.

Bad data in line 1 with error: Index was outside the bounds of the array. Resetting data to 0.0.

Uploaded CompTable 4 from PowerPMAC successfully

 

Again are these issues that Delta Tau is aware of and is it something that will be fixed ?

Link to comment
Share on other sites

  • 4 weeks later...
  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...