andreychip Posted June 17, 2014 Share Posted June 17, 2014 hi! The problem is that when turning on the details of the function G01 there is an alarm "motor on limit" and stop the drive. What kind of alarm? How to find the cause of this alarm? thank you Link to comment Share on other sites More sharing options...
steve.milici Posted June 18, 2014 Share Posted June 18, 2014 This is an indication you are on one of the "over-travel" limits. What is the exact text of the alarm message? Link to comment Share on other sites More sharing options...
andreychip Posted June 18, 2014 Author Share Posted June 18, 2014 text message "(X) Motor on limit" Alarm eliminated reduced parameter I117 from 0.2 to 0.1 Link to comment Share on other sites More sharing options...
andreychip Posted June 20, 2014 Author Share Posted June 20, 2014 Hi ! May specifically describe what this Alarm "(X) Motor on limit"? This type of alarm occurs, when the load on the drive increases . Link to comment Share on other sites More sharing options...
steve.milici Posted June 20, 2014 Share Posted June 20, 2014 We would need more details as to what PMAC you have and what is the host computer software used. This message is machine builder specific so you should consult the machine documentation. In general this probably refers to the X axis over-travel limit. The load on the drive could be killing the motor causing it to coast into the over-travel limit. Link to comment Share on other sites More sharing options...
andreychip Posted June 24, 2014 Author Share Posted June 24, 2014 we use PHMI-NC-PRO2. Thanks, at the moment everything is working Link to comment Share on other sites More sharing options...
Recommended Posts