Jump to content
OMRON Forums

documentation for racks and backplanes


Kit Richrds

Recommended Posts

I need to make schematics and drawings of a system with 26 small motors. I have been given a quote for DeltaTau and Copley equipment to accomplish this but am not finding documentation for some of the Delta Tau equipment. Can someone point me to manuals/drawings for the following?

 

300-603490-10x

Delta Tau

AMP-4-1-BP, Analog Amplifier Single Backplane Board.

 

3-2932A-01-2100-B000

Delta Tau

ACC-D3, 21-slot 3U rack. 17.00"Wide x 8.75" Deep X

5.20"High (BLACK plates)

 

5-4269-00-1821-B0100

Delta Tau

Integrated UMAC Rack w/18-Slot Backplane, 21 slot

rack & power supply, Black Plates

 

 

Thanks!

Link to comment
Share on other sites

  • Replies 8
  • Created
  • Last Reply

Top Posters In This Topic

  • 5 years later...

Mounting information and drawing can be found in the Power Brick LV manual.

http://forums.deltatau.com/filedepot/download.php?f=Power%20PMAC/Manuals/Hardware%20Reference%20Manual/Power%20Brick%20LV%20User%20Manual.pdf [FILE REMOVED]

 

The section starts on page 22 with the CAD drawing on page 24.

Link to comment
Share on other sites

Mounting information and drawing can be found in the Power Brick LV manual.

http://forums.deltatau.com/filedepot/download.php?f=Power%20PMAC/Manuals/Hardware%20Reference%20Manual/Power%20Brick%20LV%20User%20Manual.pdf [FILE REMOVED]

 

The section starts on page 22 with the CAD drawing on page 24.

 

Hi Eric, thank you for your tip, I know these drawings. What I am looking for is a drawing which defines the positions of the screws on the casing.

Link to comment
Share on other sites

Hannsx,

 

If you're referring to the holes in the casing for mounting screws, the drawing in the top left of the page Eric referred to shows just that:

 

Hi AAnikstein, I am referring to the screws holding the case together, not the holes for the mounting screws.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...