Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
M99 in main program not working
#1
Hello All

I am trying to use an M99 P304 in my main NC program. In the manual it states that this should search for N304 and execute from this line on. It does not. It seems to perform a rewind to the top of the program and stop execution. There is no alarm. If I press cycle start the program starts from beginning. I looked in the Mill.m and found that there is no real code there execpt for a "Dwell0" and a note that says it looks like there is no code here there is and that it looks to make sure the subroutine has not been deleted. Any help would be greatly helpful.

Thanks

Anthony
Reply
#2
The P address feature of the M99 code is no longer functional in NC5.x. Instead use the parametric feature of a GOTO statement.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)