11-08-2013, 04:06 AM
Dear Sir
in my old cnc's i am using baldor macro drives and i want to replace those drives with GEO GMH152/051 drives, so please post any write up, for geo macro setup with turbo pmac 2 through pewin32 pro.
as currently i am in doubt what pwn frequencies i have to set as shown in manual.
when i make setup through "geo macro drive manual", i am getting fictious noise in velocity whether motor is in open loop.
so please help.
regards
rajkumar attri
in my old cnc's i am using baldor macro drives and i want to replace those drives with GEO GMH152/051 drives, so please post any write up, for geo macro setup with turbo pmac 2 through pewin32 pro.
as currently i am in doubt what pwn frequencies i have to set as shown in manual.
when i make setup through "geo macro drive manual", i am getting fictious noise in velocity whether motor is in open loop.
so please help.
regards
rajkumar attri