Jump to content
OMRON Forums

External Time Base and EtherCAT/MACRO


andyf

Recommended Posts

If our PPMAC is using an external time base for a coordinate system and the motors in that coordinate system point to drives that are distributed on EtherCAT or MACRO networks, then any moves we command on those motor drives will use the external time base...correct?
Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Yes, that is correct. The external time base function just controls the numerical time value PMAC uses to update the mostor trajectories to the next servo cycle's set point in the fixed physical time for the servo cycle. Whether this set point is output directly to drives, as with position-mode EtherCAT drives, or used internally to close the servo loop, whose results are output to the drives, as in torque-mode or direct-PWM mode drives (whether on EtherCAT, MACRO , or a direct connection, the drives are kept in full synchronization to the external time base through this method.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...