Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Unable to run parametric program
I'm attempting to run a parametric program used on an older A600 system. The program executes to a certain block and then just stops. The number of lines versus lines in the program starts to increase rapidly and the program window shows no text with just a yellow bar.

I've stripped out the parts that the program should run based on what the parameters are and when I just run that part in a seperate program it runs fine.

Any ideas?
Solved this tonight. My var.dat file had a number of undefined entries represented by #0. I went through the list of vars, 500-599, that we use in the program and set those without values or those that represent a logical 1 versus 0 to defined 0 values. This means that their entries in the var.dat file are now represented by a 0 instead of a #0.

Forum Jump:

Users browsing this thread: 1 Guest(s)