Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ellipse in motion program
#4
(12-14-2012, 10:25 AM)JayL Wrote: In Example 1, the NORMAL command is used.
However, because of wrong break in the command line, the command got into the comment.
This is a typo.

If you look at that example again, you will see what I mean.
The command line should be:

NORMAL k-1 j (-TAN(60))


(12-12-2012, 09:33 PM)dholden Wrote: I have been looking over the ellipse example in the circular interpolation.pdf file but I have some questions about it. First the example talks about the use of a NORMAL command but this command is not listed in the example program. Second the example has a couple of blocked out areas in the example that i am guessing are important to the example.

Does anyone else have any examples on how to draw ellipses?

Thanks in advance

Seems no effect on power pmac, only circle in x-y-z space is made, what I need is an ellipse in x-y-z space. Anyone can help?
Reply


Messages In This Thread
ellipse in motion program - dholden - 12-12-2012, 09:33 PM
RE: ellipse in motion program - JayL - 12-14-2012, 10:25 AM
RE: ellipse in motion program - lovu - 08-08-2017, 05:12 PM
RE: ellipse in motion program - Gregs - 08-09-2017, 10:36 AM
RE: ellipse in motion program - lovu - 08-09-2017, 05:48 PM
RE: ellipse in motion program - AAnikstein - 08-10-2017, 09:03 AM
RE: ellipse in motion program - lovu - 08-11-2017, 02:17 AM
RE: ellipse in motion program - JayL - 08-11-2017, 10:14 AM
RE: ellipse in motion program - JayL - 08-14-2017, 01:15 PM
RE: ellipse in motion program - JayL - 08-14-2017, 04:33 PM
RE: ellipse in motion program - JayL - 08-15-2017, 10:30 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)