Jump to content
OMRON Forums

Problem restoring PMAC1


drcnc

Recommended Posts

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

if there is a structural or syntax problem in any of your PLC's this will happen. Could one of the PLC's have a bug, i.e. missing some code?

 

Using the terminal. I can run "open prog 1 clear". but I can not "open plc 1 clear". ER003

This PMAC Was off for 4 years.

I change the battery

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...