Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PMAC PC104 sequencing problem
#1
I am using a PMAC2 PC104 card. We are controlling two servo axes. The system has several PLC's, PLCC's and a motion program running. Most of the time the application performs well. Usually once in an 8 hour shift the controller will perform some of the I/O operations out of sequence, for example turning on an output, not the same one or at the same time all very random. I was wondering if anyone had seen this before. I am leaning toward resetting the device with a $$$*** and reloading all programs, maybe a program buffer corruption error. I would appreciate any advice from anyone that has seen this before. We have used Delta Tau for years running different variations of this same program, usually they are rock solid.
Reply
#2
I would suggest a complete reset and reload of your configuration as this could be a memory corruption issue.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)