How to add 2 axes to a PowerPmacNc16-SDK project

[andreychip]

Hello.
How to add 2 axes to the PowerPmacNc16-SDK project, the B-axis (circular) and the W-axis (axis built-in to the spindle), and change the subprog ComputeNCTransform?

[vinceb]

In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.

[andreychip]

(04-27-2018, 02:06 PM)vinceb Wrote: In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.

my username on GitHub AndreyErsted. My mail: Andrey.krasnynsky@gmail.com.

Thanks, I'll wait.
Andrey.

[andreychip]

(04-27-2018, 02:06 PM)vinceb Wrote: In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.

Hello!
How to get an example ?
Best regards.
Andrey.

[zerbzhang]

Please check the mail, the example project（VISUAL studio ） has been sent, please make sure you have the runtimer nc key, otherwise you can't open it.