Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Powerbrick with Rotary Motor and Linear Encoder
#3
Thanks for the reply. There were several electrical problems going on that were making everything much harder than it should have been. The Halls sensors lack pull ups so were not triggering properly. Also their was a grounding issue from the integrator's cable that was making the encoders run wild anytime it was actually powered on.

Once those were sorted I could use the manual setup to get the motor going pretending that it is a linear motor with a linear encoder.
Reply


Messages In This Thread
RE: Powerbrick with Rotary Motor and Linear Encoder - bprall - 08-02-2021, 09:08 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)