Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Large NC file execution on NON-DPRAM based PMAC2
#5
A motion program can be any size up to the memory limit of your PMAC type. If the communication is USB or Ethernet, you can view available memory under the “PMAC Resources” menu: “View User Program Memory”. The on-line “size” command will also report the amount of unused memory.

Use the PMAC Rotary Buffer feature to run programs larger than available PMAC memory. Your “GUI” interface will need to support this feature. This is documented in the “Turbo PMAC User Manual” in the section “Rotary Motion Program Buffers” starting on page 337 (353 electronic).
Reply


Messages In This Thread
RE: Large NC file execution on NON-DPRAM based PMAC2 - steve.milici - 02-02-2021, 12:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)