xuantran Posted September 7, 2020 Share Posted September 7, 2020 Hello, I would like to ask if there is a way to monitor the status of the Safety relay of the GeoMACRO Drive by software (e.g. M-variable) Link to comment Share on other sites More sharing options...
steve.milici Posted September 8, 2020 Share Posted September 8, 2020 There is no “software status” for the action of the Safety Relay. You could “monitor” the relay contact through an input but depending on how it is used, this may require “extra” electronics. Link to comment Share on other sites More sharing options...
Recommended Posts