Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"F1" help did not work in PowerPMAC IDE 4.3.2.19
#5
For the first screen shot, do you know what would have happened if you had changed the "Search" entry from "VS.Ambient" to something like Motor[x].ServoCtrl?
I suppose if you cannot get back to there, it is a moot point, but it might have been helpful for diagnostics.

If you type "Motor[x].ServoCtrl" into the Terminal window and then press "F1" key on your keyboard, what happens?
When you say the help window does not open, does your computer respond at all? Does anything happen?
Reply


Messages In This Thread
RE: "F1" help did not work in PowerPMAC IDE 4.3.2.19 - AAnikstein - 08-19-2020, 04:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)