Jump to content
OMRON Forums

PowerPMAC Clipper APM86xx freezes


andreychip

Recommended Posts

Hello!

I have a problem with the controller Clipper APM86xx freezing.

I am using Power PMAC-NC 8 axes. In manual mode, everything works well.

In Auto and MDI mode, when starting on the G0X100Z-100 frame, the controller starts moving and freezes (stops working).

It starts to work after a full reboot.

What could be?

 

Сontroller configuration 8 axis .

ACC-8FS -2 boards

ACC-24S3-1 board

Thanks in advance for your help.

IMG_5701.JPG.06218674f94b15a3e06b06c415d4062a.JPG

IMG_5703.JPG.9ce8d12b0f179b65e26f2f7a6d7e8f23.JPG

IMG_5705.JPG.3deae869afaf11ccaf50d095e4c1a2ca.JPG

IMG_5706.JPG.265f384459477e859331780d6996efd5.JPG

IMG_5708.JPG.67fef9596bd4c5fd1f63e5d71142c1a7.JPG

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Hello!

I figured out the problem. The problem is firmware 2.4.0.180.

When I replaced the controller with a new one, everything worked with firmware 2.5.0.4 . I updated PowerPMAС to version 2.5.0.4 and it worked.

I upgraded PowerPMAK to version 2.5.0.4 and it worked. Where can I get the latest update for CPU 465(Clipper)?

Thank you!

Andrey.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...