hjpark Posted March 6, 2020 Share Posted March 6, 2020 Long-Form Command, like 'Jog/ 1' 'abort prog1', does not work But if I write two lines, it works. like this, abort prog1 abort prog1 Jog/ 1 Jog/ 1 Not always. Sys.NoShortCmds is set to 0. Are there any more parameters I should check? Link to comment Share on other sites More sharing options...
Alex Anikstein Posted March 6, 2020 Share Posted March 6, 2020 Where are you issuing the commands? If you are trying in the terminal window, that syntax is incorrect--it would be "&1 abort" and "#1 Jog/". If you are trying from inside of a script, the syntax for the first set is still incorrect--it would just be "abort 1", as you abort an entire coordinate system, not a specific motion program. I suspect that your commands are "working" the first time, but addressing the wrong motor/coordinate system. Link to comment Share on other sites More sharing options...
hjpark Posted March 9, 2020 Author Share Posted March 9, 2020 Thanks for reply. I will check the error of syntax. Link to comment Share on other sites More sharing options...
Recommended Posts