Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lookahead is not working
#7
(03-10-2020, 11:32 AM)curtwilson Wrote: Your behavior indicates that lookahead is not active for some reason. In segmentation mode, the move-by-move limits are not active, but the segment-by-segment limits require lookahead to be active.

In the Executive program, select the View tab, then select "Specialized Buffers". Does it show a lookahead buffer?

Even though you don't seem to need much lookahead, try defining a larger buffer and a longer lookahead distance.
Thank you curt, I had found the reason for this error, the look-ahead buffer was deleted when I used “$$$” to reset the system.
Reply


Messages In This Thread
Lookahead is not working - forever - 02-25-2020, 07:42 PM
RE: Lookahead is not working - curtwilson - 02-27-2020, 01:23 PM
RE: Lookahead is not working - forever - 02-27-2020, 06:44 PM
RE: Lookahead is not working - curtwilson - 02-28-2020, 05:22 PM
RE: Lookahead is not working - forever - 02-28-2020, 08:43 PM
RE: Lookahead is not working - curtwilson - 03-10-2020, 11:32 AM
RE: Lookahead is not working - forever - 03-13-2020, 07:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)