Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lookahead is not working
#1
We use Turbo clipper for the first time, we made a test using an example in PMAC training course for the lookahead, as anticipate the velocity will decelerate in the corner if lookahead working, but actually the velocity is remain unchanged. I have no idea about the question, can sb. give me some help pls?
the code is as below
Undefine All
&1
#1->1000X
#2->1000Y
I5049 = 10
I5000 = 1
I5113 = 5
I5192 = 0
I116 = 50
I117 = .5
I216 = 50
I217 = .5
I5120 = 4/3/2*I116/I117/I5113
End Gat
Del Gat
Del Rot
Del Comp
Del Look
Close
Define Lookahead 13, 50
Open Prog 1 Clear
Linear Abs
CMD"End Gat"
CMD"Del Gat"
CMD"Def Gat"
Dwell 0
CMD"Gat"
Dwell 0
F 50
X 10 Y 10
X 0 Y 20
Dwell 0
Cmd "End Gat"
Dwell 0
Close
Reply


Messages In This Thread
Lookahead is not working - forever - 02-25-2020, 07:42 PM
RE: Lookahead is not working - curtwilson - 02-27-2020, 01:23 PM
RE: Lookahead is not working - forever - 02-27-2020, 06:44 PM
RE: Lookahead is not working - curtwilson - 02-28-2020, 05:22 PM
RE: Lookahead is not working - forever - 02-28-2020, 08:43 PM
RE: Lookahead is not working - curtwilson - 03-10-2020, 11:32 AM
RE: Lookahead is not working - forever - 03-13-2020, 07:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)