Jump to content
OMRON Forums

GBLV max ADC frequency


brinj

Recommended Posts

At some point since 2009 the GeoBrick Default I7m03 changed from 1234 to 2257.

 

I understand that this was for reasons of limiting either the maximum ADC or DAC frequency.

 

I have recently used a 1A geobrick variant and selected the recommended 40kHz PWM frequency , but at this rate the ADC values as read by Mxx05 are random and range from zero to full scale, even without motor power.

 

If I reduce the ADC clock divider from 3 to 2 this reading becomes stable , but I want to be sure I don't exceed the new maximum allowable settings.

 

Does anyone on here know what the maximum allowable settings are for the hardware clock settings of an 8 channel 1A/3A geobrick LV running at 210MHz. ( avoiding 240 just in case we have some older hardware that predates the wait states firmware fix)

 

Thanks in advance

Link to comment
Share on other sites

  • Replies 0
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...