Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ECAT Setup in IDE4
#4
Doug,

1) On the Amplifier page, did you make sure to click the "Accept" button on that page? If there is an "Update Database" button, at one point I know there was a bug associated with that and EtherCAT drives, though from your screenshot, you seem to be using a newer version of the IDE after that was fixed.

2) Did you map your input and output PDOs? If there are no PDOs mapped that can be used for those signals, they may show up as Hardware Mismatch.

3) If you click on the "Hardware Mismatch", can you just verify that there is nothing else in the dropdown--that Hardware Mismatch is the only option?
Reply


Messages In This Thread
ECAT Setup in IDE4 - thuglas - 03-26-2019, 01:43 PM
RE: ECAT Setup in IDE4 - Eric Hotchkiss - 03-26-2019, 01:57 PM
RE: ECAT Setup in IDE4 - thuglas - 03-26-2019, 02:55 PM
RE: ECAT Setup in IDE4 - AAnikstein - 03-26-2019, 05:08 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)