02-28-2019, 10:03 AM

Assuming this is the only motor in the coordinate system and the code has been downloaded.

Using the terminal:

First put the motor in closed loop with #1J/

Then run the program with &1B1R

(The first 1 is the coordinate system, the second is the program number.)

From a PLC:

First put the motor in closed loop with Jog/ 1

And run the program with START 1:1

(The first 1 is the coordinate system, the second is the program number.)

Using the terminal:

First put the motor in closed loop with #1J/

Then run the program with &1B1R

(The first 1 is the coordinate system, the second is the program number.)

From a PLC:

First put the motor in closed loop with Jog/ 1

And run the program with START 1:1

(The first 1 is the coordinate system, the second is the program number.)