Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Velocity dependent backlash
#1
I'm on a PMAC Mini (PMAC 1).

I have a worm gear coupled to a motor via a flexible shaft adapter.

I run with minimal blending, (I187=1, I188=0), and reverse the motor while it is rotating at varying velocities. The backlash introduced by the shaft adapter seems to vary with velocity.

Does that mean I have to set up a backlash table, as opposed to just adjusting backlash iVars?
Reply


Messages In This Thread
Velocity dependent backlash - GuitarBrad - 02-05-2019, 07:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)