Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Global P variables in background C-PLCs
#2
I have found that you need to not only execute the “Clean” but an “Unload” and “Reload” of the project. Also if you have any of the buffer sizes in the project properties different from the default you must also execute a reboot (or power cycle) at least once after the first “build and Download” after the firmware update. I was able to recreate the issue but resolved it after doing the above actions.
Reply


Messages In This Thread
RE: Global P variables in background C-PLCs - steve.milici - 01-28-2019, 02:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)