Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACC-24E2S encoder counter register
#1
I used ACC-24E2S and set I7mn0 =8 to make it run in open loop, but the encoder still connected to board, so is it possible to get encoder counter to verify its position, if it is ok, which register can be read? for example ,Servo IC 2, channel 1, I try to read the value which point toM101-> X:$078201,0,24,S,it's failure.
Reply


Messages In This Thread
ACC-24E2S encoder counter register - guoke1225 - 01-18-2019, 12:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)