Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to run motion program
The "3" in the motor status word tells you that it thinks it is into both minus and plus hardware limits, so refuses to move in either direction. I presume this is a simulated system, so the easiest solution is to disable the HW limit function for each motor by setting Motor[x].pLimits to 0.

(This is a Power PMAC question that you posted in the Turbo PMAC list. It may get moved to the proper list soon.)

Messages In This Thread
how to run motion program - twathit - 09-11-2018, 12:36 AM
RE: how to run motion program - curtwilson - 09-12-2018, 04:48 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)