Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Acc24E3 Amp Enable Relay
#4
(07-18-2018, 02:01 PM)steve.milici Wrote: These are solid state relays. You should be able to download the QC specs from the manufacturer. These have shown to be very reliable. Please contact support@deltatau.com with the card s/n to investigate this issue.

On the one card here I have here I found a dry joint on one of the legs of the gull wing package. A parting line was clearly visible under the Mantis. Probing the pin easily lifted it away from the pad. Possible causes clogged stencil, insufficient paste since this is near the edge of the board, or un-level pins on the component.
Reply


Messages In This Thread
Acc24E3 Amp Enable Relay - JeffLowe - 07-18-2018, 07:16 AM
RE: Acc24E3 Amp Enable Relay - ibisjoe - 07-18-2018, 07:34 AM
RE: Acc24E3 Amp Enable Relay - JeffLowe - 09-07-2018, 01:02 PM
RE: Acc24E3 Amp Enable Relay - JeffLowe - 07-19-2018, 12:34 PM
RE: Acc24E3 Amp Enable Relay - JeffLowe - 09-11-2018, 05:14 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)